10/31/2023 0 Comments Best 3d piping design software![]() There wouldn't be much point in compressing the air to the high pressures you mention, only to lose it in the piping. The 4" pipe would be the usual "economic" diameter to use. If you are designing for a life span of 5 to 10 years you can expect the roughness to double or treble over that period. A standard 2" NB pipe would of course give a pressure drop quite a bit less than this.īy the way, these calculations are all based on the "new" condition pipe roughness. If you could get a 1.9" pipe, the pressure drop would be about 125 PSI/100ft. The major difference between using the two different sizes would be the pressure drop. That can only be answered knowing what the duty is. I suppose your real question was whether you should use a 4" pipe or a 2" one. ![]() Concerning your compressed air application:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |